Hodgman Core INS Wader Liner

The Hodgman Core INS Wader Liner is a removable liner system that provides first-rate insulation to your lower body and is compatible with any Hodgman wader that accepts the Core INS System.

This extra layer is perfect for winter months and incorporates Thinsulate fabric technology that keeps you incredibly warm. Even when you are submerged in cold water, this liner will help ensure the biting chill doesn’t reach your legs. The moisture resistant, breathable construction keeps you warm even when wet and the fleece upper fabric provides excellent insulation for added comfort.

The Hodgman Core INS Wader Liner is easy to use and can be installed into your waders in a few minutes by following these easy steps.

1. Lay the wader and the liner face up next to each other on the ground.

2. Unbuckle the shoulder straps to allow access to the inside of the wader. (On the drop top designs included on the Aesis Sonic waders remove the Velcro attachment point located on the rear buckle instead of unbuckling the front of the wader).

3. Reach inside the wader and pull the right leg of the wader inside out to expose the connection snap points located at the inside top of the stocking foot bootie.

4. Connect the liner to the wader by snapping the corresponding green snaps to green connection points on the wader and the red to red connection points. Then snap the front and back connection points in place. (Be sure the leg on the Core INS liner is not twisted).

5. Reach inside the wader and pull the left leg inside out and connect the corresponding red, green and black connection points as you did in step 3.

6. Grab the stocking foot of each wader leg and pull to turn the wader right side out. The liner will be pulled inside your wader as the wader is turned right side out.

7. Secure the upper portion of the removable liner to the wader using the two zippers located on the upper inside of the wader. The zippers are under the flap of fabric just inside the top of the wader.

When the liner is installed in your wader it is recommended you point your toe when putting on the wader. This will prevent your toe from pushing fabric over the entrance hole into the stocking foot bootie.

The Hodgman Core INS Wader Liner is Charcoal in colour and is available in a range of sizes suitable for fitting your CORE INS compatible waders.

Core INS removable multi-zone breathable wader insulation system
Gives added warmth in the legs and seat that are most often submerged
Thinsulate moisture resistant insulation
Provides more warmth than other insulation even when damp from sweat vapour
Easy on and off design, slip in and out of wader easily and eliminates binding in knees
Warm fleece upper
Easily zips and snaps in minutes into any Hodgman wader that accepts Core INS System